Tesla Model 3: Refrigerant System
Tesla Model 3 2017-2024 Service Manual / Thermal Management / Refrigerant System
- A/C Refrigerant Leak Detection
- A/C Refrigerant (Recovery and Recharge)
- Chiller and EXV Assembly (Remove and Replace)
- Compressor (Remove and Replace)
- Condenser (Remove and Replace)
- Evaporator (Clean)
- Evaporator (Remove and Replace)
- Module - Cooling Fan (Remove and Install)
- Module - Cooling Fan (Remove and Replace)
- Mounting - A/C Compressor (Remove and Replace)
- Pipe - High Pressure - Compressor to Condenser (Remove and Replace)
- Pipes - Refrigerant - High / Low Pressure (Remove and Replace)
- Pressure Transducer - High Pressure (Remove and Replace)
- Pressure Transducer - Low Pressure (Remove and Replace)
- Receiver Dryer and Desiccant (Remove and Replace)
- TXV Valve - Evaporator (Remove and Replace)
READ NEXT:
A/C Refrigerant Leak Detection
SPECIAL TOOLS
Tool, Flashlight, UV (1053591-00-A)
UV Leak Detection Kit (1080563-01-A)
Procedure
Remove the rear underhood apron. See
Underhood Apron - Rear (Remove and Replace).
Remove the cabi
A/C Refrigerant- DRAFT
Warning:
This procedure was derived from pre-production computer models, and
might not reflect the real-world situation. Warnings and cautions might be
missing. Follow safety requirements and use
SEE MORE:
Link - Fore - Lower - Rear - LH - Install
Install
Install the LH rear lower fore link to the subframe,
and then hand-tighten the bolt that attaches the LH rear
lower fore link to the subframe.
Latch - Hood (Remove and Replace)
Remove
Remove the rear underhood apron. See Underhood Apron - Rear (Remove and
Replace).
Remove the cabin intake duct. See Duct - Cabin Intake (Remove and
Replace).
Remove the hood latch cover. See Cover - Hood Latch (Remove and
Replace).
Remove the underhood storage unit. See Underhoo
© 2019-2024 Copyright www.tmodel3.com
