Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Harness - Windshield- Remove

Tesla Model 3 2017-2025 Service Manual / Electrical / Harnesses / Harness - Windshield (Remove and Replace) / Harness - Windshield- Remove

Harness - Windshield (Remove and Replace)

Remove

  1. Remove the LH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace).
  2. Remove the LH middle A-pillar trim. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  3. Remove the LH lower A-pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace).
  4. Remove the LH upper A-pillar trim. See Trim - A-Pillar - Upper - LH (Remove and Replace).
  5. Remove the driver sun visor. See Sun Visor - Driver (Remove and Replace).

Harness - Windshield- Remove

  1. Release the driver sun visor base cover clips, and then remove the base cover from the vehicle.

Harness - Windshield- Remove

  1. Remove the bolt that attach the driver sun visor base to the body, and remove the base from the vehicle.
  2. Remove the lower quad camera cover. See Quad Camera Cover - Lower (Remove and Replace).
  3. Remove the rear view mirror. See Mirror - Rear View (Remove and Replace).
  4. Remove the forward facing camera. See Camera - Forward Facing (Remove and Replace).
  5. Repeat steps 1 through 7 on the RH side of the vehicle.
  6. Release the clips (x3) that attach the headliner by pulling downwards at the front center of the headliner.

Harness - Windshield- Remove

  1. Disconnect the windshield harness electrical connectors, and then pull the windshield harness up through the opening on the instrument panel.

Harness - Windshield- Remove

  1. Release the clips that attach the windshield harness to the RH A-pillar.

Harness - Windshield- Remove

  1. Release the clips that attach the windshield harness along the top portion the windshield, and then remove the harness from the vehicle.

    READ NEXT:

     Harness - Windshield- Install

    Install Secure the clips that attach the windshield harness to the RH A-pillar. Connect the windshield harness electrical connectors. Install the forward facing camera. See Camera - Forward

     Electronic Control Modules

     Module - Body Controller - Front (Dual Motor) (Remove and Replace)

    SEE MORE:

     Panel - Door Trim - Front - LH (Remove and Install) - Install

    Install Inspect the condition of the LH front door and the LH front door trim panel. Replace any broken clips and repair any damage. Bring the trim panel to the door, and rest it on the door edge. If present, remove and discard the highlighted clip. Attach harness to hooks (highlight

     Applique - B-Pillar - LH (Remove and Replace) - Install

    Install Connect the camera connectors to the B-pillar applique, and then position the applique onto the vehicle. Install the bolts that attach the B-pillar applique to the body.  Torque 5 Nm Position the B-pillar applique fastener cover onto the vehicle, and then engage th

    © 2019-2025 Copyright www.tmodel3.com