Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Harness - Windshield- Install

Install

Harness - Windshield- Install

  1. Secure the clips that attach the windshield harness to the RH A-pillar.

Harness - Windshield- Install

  1. Connect the windshield harness electrical connectors.
  2. Install the forward facing camera. See Camera - Forward Facing (Remove and Replace).

Harness - Windshield- Install

  1. Secure the windshield harness with the clips along the top of the windshield.
  2. Install the clips (x3) that attach the front center of the headliner to the body.

Harness - Windshield- Install

  1. Install the bolt that attach the front passenger visor base to the body. Torque 3 Nm

Harness - Windshield- Install

  1. Install the front passenger sun visor base cover clips.
  2. Install the front passenger sun visor. See Sun Visor - Driver (Remove and Replace).
  3. Install the RH upper A-pillar trim. See Trim - A-Pillar - Upper - LH (Remove and Replace).
  4. Install the RH lower A-pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace).
  5. Install the RH middle A-pillar trim. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  6. Install the RH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace).
  7. Repeat steps 6 through 12 on the LH side of the vehicle.
  8. Perform the forward facing camera target calibration procedure. See Camera - Forward Facing (Target Calibration)

    READ NEXT:

     Electronic Control Modules

     Module - Body Controller - Front (Dual Motor) (Remove and Replace)

     Module - Body Controller - Front (Dual Motor) - Remove

    Remove Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace). Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace). Remov

    SEE MORE:

     Four Wheel Alignment (Check)

    SPECIAL TOOLS SEAT COVER (1096767-00-A) Ballast Bag, 25lb (1145158-00-A) CHASSIS HEIGHT MEASURING TOOL (1071271-00-A) STEERING WHEEL LEVEL (1049463-00-A) Procedure Make sure the tire pressures are to specification. Note: Use the tire sticker values displayed on the door jam. If unavailable, use

     Automatic Emergency Braking

    The forward looking camera(s) and the radar sensor are designed to determine the distance from a detected object traveling in front of Model 3. When a frontal collision is considered unavoidable, Automatic Emergency Braking is designed to apply the brakes to reduce the severity of the impact.

    © 2019-2025 Copyright www.tmodel3.com