Tesla Model 3: Electronic Control Modules
Tesla Model 3 2017-2026 Service Manual / Electrical / Electronic Control Modules
- Module - Body Controller - Front (Dual Motor) (Remove and Replace)
- Module - Body Controller - Front (RWD) (Remove and Replace)
- Module - Body Controller - LH (Remove and Replace)
- Module - Body Controller - RH (Remove and Replace)
- Module - HomeLink Transmitter (Remove and Replace)
READ NEXT:
Module - Body Controller - Front (Dual Motor) (Remove and Replace)
Module - Body Controller - Front (Dual Motor) - Remove
Remove
Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd
Row (Remove and Replace).
Remove the rear underhood apron. Se
SEE MORE:
Condenser (Remove and Replace)
Remove
Remove the cooling fan module. See
Module - Cooling Fan (Remove and Install).
Release the clips (x14) that attach the active grille shutter to the
cooling fan module, and then remove the active grille shutter from the
module.
Remove the screws (x2) that attach the radiato
Pressure Transducer - Low Pressure (Remove and Replace)
Remove
Recover the A/C refrigerant. See A/C Refrigerant (Recovery and Recharge).
Note: Completely recover the refrigerant before continuing this
procedure.
Disconnect 12V power. See 12V Power (Disconnect and Connect).
Disconnect the electrical connector to the low pressure transducer.
© 2019-2026 Copyright www.tmodel3.com
