Tesla Model 3: Body Panels
Tesla Model 3 2017-2025 Service Manual / Body / Body Panels
- Brace - Shock Tower (Remove and Replace)
- Bracket - Crash Can - LH (Remove and Replace)
- Carrier - Front End (Remove and Replace)
- Door - Front - LH (Remove and Install)
- Door - Front - LH (Remove and Replace)
- Door - Rear - LH (Remove and Install)
- Door - Rear - LH (Remove and Replace)
- Fender Assembly - Front - LH (Remove and Replace)
- Hood (Remove and Install)
- Hood (Remove and Replace)
- Trunk (Remove and Install)
- Trunk (Remove and Replace)
READ NEXT:
Brace - Shock Tower (Remove and Replace)
Remove
Open all the doors.
Lower all the windows.
Remove the 2nd row lower seat cushion.
Remove the rear underhood apron.
Remove the cabin intake duct.
Remove the underhood storage unit
Dis
Bracket - Crash Can - LH (Remove and Replace)
DRAFT
Warning:
This procedure was derived from pre-production computer models, and
might not reflect the real-world situation. Warnings and cautions might be
missing. Follow safety requirements
SEE MORE:
Seat Cushion - Lower - 2nd Row (Remove and Replace)
Remove
Move the driver seat and the front passenger seat fully forward.
Note: Note the position of the driver seat and the front passenger
seat prior to movement so that both seats are restored to their original
position during installation.
While pressing the LH and RH tabs towards the
Module - Body Controller - Front (RWD) - Install
Install
Set the front body controller module where it installs into the vehicle,
and then tilt the module forward
Install the ground strap to the lower rear of the front body controller
module, and then install the bolt that attaches the ground strap to the
module.
Torque 9 Nm
© 2019-2025 Copyright www.tmodel3.com
