Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Rear Gearbox and Halfshafts

READ NEXT:

 Breather - Rear Drive Unit (Remove and Replace)

Remove Remove the rear subframe assembly. See Subframe Assembly - Rear (Remove and Install).

 Filter - Oil - Rear Drive Unit (Remove and Replace)

SPECIAL TOOLS Skt, Oil Filter, 63.5mm X 14 (1130484-00-A) Kit, Drive Unit Oil Drain, Model 3 (1134264-00-A) Procedure

 Gearbox - Rear Drive Unit (Remove and Replace)

Remove Remove the rear drive unit inverter. See Inverter - Rear Drive Unit (Remove and Install). Setup

SEE MORE:

 USB Hub - Center Console - Front (Remove and Replace)

Remove Remove the center console. See Center Console (Remove and Install). Disconnect the electrical wiring harness connector from the USB hub. Release the clips that attach the electrical harness to the USB hub. Remove the bolts that attach the USB hub to the center console, and

 Vent Assembly - HV Battery - LH (Remove and Replace)

Vent Assembly - HV Battery - LH- Remove Remove Use Toolbox to put the vehicle into Factory Mode. Invoke diagnostics on the touchscreen. Inspect the Notifications for either a BMS_a123 or a BMS_W123 alert. If: Either alert is present - Contact Service Engineering. Do not perform this proced

© 2019-2026 Copyright www.tmodel3.com