Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Panel - Door Trim - Rear - LH (Remove and Install) - Remove

Panel - Door Trim - Rear - LH (Remove and Install)

Remove

  1. Open the LH rear door, and fully lower the window.

Panel - Door Trim - Rear - LH (Remove and Install)- Remove

  1. Remove the LH rear door puddle light. See Puddle Light - Rear Door - LH (Remove and Replace).

Panel - Door Trim - Rear - LH (Remove and Install)- Remove

  1. Release the clip that attaches the screw cover to the front of the LH rear door armrest, and then remove the screw cover from the armrest.

Panel - Door Trim - Rear - LH (Remove and Install)- Remove

  1. Remove the screws that attach the trim panel to the door. Torque 6 Nm

Trim Panel Clip Locations
Trim Panel Clip Locations

  1. Pull out on the trim panel from the puddle light opening to release the clips that attach the trim panel to the door.

Caution:

Do not remove the trim panel from the door at this time.

Door Clip Locations
Door Clip Locations

  1. Continue to pull and release all of the clips around the edge of the trim panel, working from the bottom up.

Caution:

Do not remove the trim panel from the door at this time.

Trim Panel Connectors
Trim Panel Connectors

Door Electrical Harness Connectors
Door Electrical Harness Connectors

  1. Detach the manual release cable, disconnect the electrical wiring harness from the connectors, and then release the clip that attaches the electrical harness to the trim panel.

Caution:

Do not remove the trim panel from the door at this time.

  1. Raise the trim panel up to unhook it from the door, and then remove the panel from the door.

    READ NEXT:

     Panel - Door Trim - Rear - LH (Remove and Install) - Install

    Install Inspect the condition of the LH rear door and the LH rear door trim panel. Replace any broken clips and repair any damage. Bring the trim panel to the door, and rest it on the door edge.

     Panel - Door Trim - Rear - LH (Remove and Replace)

    Remove Remove the rear LH door panel. See Panel - Door Trim - Rear - LH (Remove and Install). Release the clips that attach the puddle lamp to the door panel, and then remove the lamp fr

     Pillar and Sill Trim

    SEE MORE:

     12V Power - Connect

    Connect Remove the logic connector cap from the high voltage controller connector. Connect the electrical harness to the high voltage controller connector. Install the foam cover to the RH side of the penthouse. Install the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd

     Lane Changes

    Navigate on Autopilot changes lanes to either prepare Model 3 for an upcoming off-ramp, to increase your driving speed (not to exceed your set cruising speed), or to move Model 3 out of a left-most lane when you are not passing other vehicles. A message displays at the top of the map's tur

    © 2019-2025 Copyright www.tmodel3.com