Tesla Model 3 Owners & Service Manuals

Tesla Model 3: 12V Power - Connect

Connect

12V Power- Connect

  1. Remove the logic connector cap from the high voltage controller connector.

12V Power- Connect

  1. Connect the electrical harness to the high voltage controller connector.

12V Power- Connect

  1. Install the foam cover to the RH side of the penthouse.
  2. Install the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).

12V Power- Connect

  1. Connect the 12V battery negative cable to the battery, and then tighten the nut which secures the terminal clamp around the battery post. Ensure that the terminal clamp is fully seated down on the battery post before tightening. Torque 6 Nm
  2. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Press the brake pedal to turn on vehicle power.
  4. Remove the shop towels from the rear door strikers.
  5. Close the rear doors.
  6. Return the windows, seats, climate control, audio, and charging to the state before service.

    READ NEXT:

     Battery - 12V (Remove and Replace)

    Remove Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace). Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace). Remove

     Beam - 12V Battery (Dual Motor) (Remove and Replace)

    Remove Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace). Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace). Remove

     Beam - 12V Battery (RWD) (Remove and Replace)

    SEE MORE:

     Seal - Hood (Remove and Replace)

    Remove Open the hood. Release the seal from the underhood storage unit, and then remove the seal from the underhood storage unit. Install Installation procedure is the reverse of removal, except for the following: During installation, align the line from the seal to the line from the

     Brace - Shock Tower (Remove and Replace)

    Remove Open all the doors. Lower all the windows. Remove the 2nd row lower seat cushion. Remove the rear underhood apron. Remove the cabin intake duct. Remove the underhood storage unit Disconnect the 12V power. Remove the 12V auxiliary battery. Support the A/C compressor from below.

    © 2019-2025 Copyright www.tmodel3.com