Tesla Model 3: Panel - Door Trim - Rear - LH (Remove and Install) - Install

Install

1. Inspect the condition of the LH rear door and the LH rear door trim panel. Replace any broken clips and repair any damage.
2. Bring the trim panel to the door, and rest it on the door edge.

3. Fasten the clip that attaches the electrical wiring harness to the trim panel.

4. Connect the short wire off of the electrical harness to the speaker.

Warning: If the door light connector is plugged into the speaker, the speaker is permanently damaged and might cause melting. Do not interchange the electrical harness speaker connector and door light connector.

5. Connect the electrical harness to the LH rear door trim panel connectors.

6. Lift the trim panel, compress the LH rear door inner belt seal slightly, and hook the three trim panel tabs into the top edge of the door.
7. Move the electrical harness connector for the puddle light out the hole in the bottom of the trim panel.
8. Install the LH rear door puddle light. See Puddle Light - Rear Door - LH (Remove and Replace).
9. Make sure that the puddle light and map pocket ambient light illuminate when connected.
10. Fasten the clips that attach the trim panel to the door.
11. Make sure that the trim panel fits tightly, and that there are no gaps from misaligned or bent clips.

12. Install the screws that attach the LH rear door trim panel to the LH rear door. Torque 6 Nm

Note: Make sure that all fasteners are properly torqued and not cross-threaded.

13. Install the screw cover to the front of the armrest.
14. Raise the window and close the door.

READ NEXT: