Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Harness - Trunk- Remove

Harness - Trunk (Remove and Replace)

Remove

  1. Remove the package tray trim. See Trim - Package Tray (Remove and Install).

Harness - Trunk- Remove

  1. Disconnect the trunk electrical harness connectors.

Harness - Trunk- Remove

  1. Remove and discard the bolt that attaches the ground strap to the body.

Harness - Trunk- Remove

  1. Push the trunk electrical wiring harness through the bulkhead.
  2. Remove the trunk trim panel. See Trim - Lid - Trunk (Remove and Replace).

LH
LH

RH
RH

  1. Disconnect the LH and RH trunk light connectors.

Harness - Trunk- Remove

  1. Disconnect the backup camera connector, the trunk handle connector, and the LH and RH license plate light connectors.

Harness - Trunk- Remove

  1. Disconnect the trunk latch connector.

Harness - Trunk- Remove

  1. Remove and discard the bolts (x2) that attach the trunk electrical harness ground straps to the trunk lid.

Harness - Trunk- Remove

  1. Release the clips that attach the trunk harness to the trunk lid.

Harness - Trunk- Remove

  1. Push the harness through the trunk bulkhead and out of the trunk lid.

    READ NEXT:

     Harness - Trunk- Install

    Install Move the trunk electrical harness in through the trunk bulkhead. Fasten the clips that attach the trunk electrical harness to the trunk lid. Install new bolts (x2) to attach th

     Harness - Windshield (Remove and Replace)

     Harness - Windshield- Remove

    Remove Remove the LH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace). Remove the LH middle A-pillar trim. See Trim - A-Pillar - Middle - LH (Remove and Repl

    SEE MORE:

     HV Header - Inverter - Rear Drive Unit - Remove

    SPECIAL TOOLS Extractor, Drive Unit HV Header, Model 3 (1142608-00-B) Lever Lock, HV Connector, Model 3 (1140311-00-A) Warning:

     Receiver Dryer and Desiccant- Install

    Install Use 3/8 inch extensions to press the new desiccant filter into the condenser. Lightly tap with a hammer to fully seat the filter. Insert a new desiccant bag into the condenser. Install the inner cap into the condenser, and press it in just below the groove for the snap ring. Remove

    © 2019-2024 Copyright www.tmodel3.com