Tesla Model 3: General Information
Tesla Model 3 2017-2026 Service Manual / General Information
- Introduction
- Best Practices
- Electrical Precautions
- General Precautions
- Environmental Precautions
- General Fitting Instructions
- Locking Devices
- Airbag and Supplementary Restraint System (SRS) Precautions
- Air Conditioning System Precautions
- Charging
- Technical Data
- Identification Numbers
- Fluids and Capacities
READ NEXT:
How to Use this Manual
General
Caution:
Only qualified technicians should attempt to perform the procedures
contained within this manual.
This manual is organized by vehicle subsystem. Click on a subsystem in
the lef
Repairs and Replacements
Only use Tesla recommended parts.
Warning: Non-Tesla recommended parts might adversely affect
safety features and corrosion prevention treatments.
Warning: Always use the correct torque values as gi
SEE MORE:
Tesla Badge - Front (Remove and Replace)
SPECIAL TOOLS
Kit, Badge Removal (1453028-00-A)
Fixture, Front Badge, Model 3 (1134702-00-A)
Remove
Prepare the badge removal tool with approximately 60 centimeters of
monofilament line.
With the hood closed, position the badge removal tool so that the
monofilament line cuts under a corner
Module - HomeLink Transmitter (Remove and Replace)
Remove
Remove the front fascia. See Fascia - Front (Remove and Install).
Disconnect the electrical connector from the HomeLink transmitter module.
Release the tab, and then slide the HomeLink transmitter
module to the right to remove it from the vehicle.
Install
Install the
© 2019-2026 Copyright www.tmodel3.com
