Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Fuse - Power Conversion System - HV Battery- Remove

Tesla Model 3 2017-2025 Service Manual / Battery System / HV Battery Electrical Components / Fuse - Power Conversion System - HV Battery (Remove and Replace) / Fuse - Power Conversion System - HV Battery- Remove

Fuse - Power Conversion System - HV Battery (Remove and Replace)

SPECIAL TOOLS

Ratchet, 1/4" Sq Dr, HV Insulated (1057602-00-A)

Ext Bar, Wobble, 1/4" Dr, HV Insulated (1057603-00-A)

Skt, 1/4" Sq Dr, 8mm, HV Insulated (1057604-00-A)

Magnet, Flexible, HV Insulated, 18" (1057607-00-A)

Asy, Service Cover, Penthouse, Model 3 (1127845-00-A)

Warning:

Only technicians who have been trained in High Voltage Awareness are permitted to perform this procedure. Proper personal protective equipment (PPE) and insulating HV gloves with a minimum rating of class 0 (1000V) must be worn at all times a high voltage cable, busbar, or fitting is handled. Refer to Tech Note TN-15-92-003, "High Voltage Awareness Care Points" for additional safety information.

Remove

  1. Remove the pyrotechnic battery disconnect from the penthouse. See Pyrotechnic Battery Disconnect (Remove and Replace).

Fuse - Power Conversion System - HV Battery- Remove

  1. Raise the high voltage controller, release the clips that attach the fuse access insulator to the RH penthouse bus cover, and remove the insulator.

Fuse - Power Conversion System - HV Battery- Remove

  1. Remove and discard the nuts that attach the power conversion system fuse to the RH penthouse bus and remove the fuse.

    READ NEXT:

     Fuse - Power Conversion System - HV Battery- Install

    Install Install the power conversion system fuse to the RH penthouse bus, and then install new nuts to attach the fuse to the bus. Torque 2.5 Nm Generic Measurement - Actual busbars and f

     Guide - Probing - HV Battery (Remove and Replace)

     Guide - Probing - HV Battery- Remove

    SPECIAL TOOLS Ratchet, 1/4" Sq Dr, HV Insulated (1057602-00-A) Ext Bar, Wobble, 1/4" Dr, HV Insulated (1057603-00-A) Skt, 1/4" Sq Dr, 13mm, HV Insulated (1057606-00-A) Magnet, Flexible, HV Insulated

    SEE MORE:

     Latch - Hood (Remove and Replace)

    Remove Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace). Remove the cabin intake duct. See Duct - Cabin Intake (Remove and Replace). Remove the hood latch cover. See Cover - Hood Latch (Remove and Replace). Remove the underhood storage unit. See Underhoo

     Windshield (Remove and Install)- Windshield Preparation

    Windshield Preparation Use a razor blade and a blade scraper to remove the old urethane from the windshield flange on the vehicle. Install the GPS antenna into the windshield bracket, and then install the screw that attaches the GPS antenna to the bracket.   Torque 1 Nm Insta

    © 2019-2025 Copyright www.tmodel3.com