Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Rear Suspension (Including Hubs)

Tesla Model 3 2017-2025 Service Manual / Suspension / Rear Suspension (Including Hubs)

READ NEXT:

 Cover - Rear Suspension - LH (Remove and Replace)

Remove Remove the bolt that attaches the rear suspension cover to the LH lower rear control arm assembly. Torque 6 Nm Release the tabs (x2) that attach the rear suspension cover to the LH

 Drop Link - Stabilizer Bar - Rear - LH (Remove and Replace)

Remove Remove the mid aero shield. See Panel - Aero Shield - Mid (Remove and Replace). Remove and discard the nuts that attach the LH drop link to the rear stabilizer bar and rear LH knuck

 Hub - Rear - LH (Remove and Replace)

Remove Remove the LH rear brake rotor. See Brake Rotor - Rear - LH (Remove and Replace). Remove the LH rear drive unit halfshaft. See Halfshaft - Rear Drive Unit - LH (Remove and Replace).

SEE MORE:

 Brake Rotor - Rear - LH (Remove and Replace)

SPECIAL TOOLS Tool, Caliper Spreader, Model 3 (1134786-00-A) Remove Raise the vehicle and remove the LH rear wheel. See Wheel (Remove and Install). Use Toolbox to place the vehicle into EPB Service Mode. See Release Parking Brake Using Toolbox Disconnect the electrical wiring harness con

 Tesla Badge - Front (Remove and Replace)

SPECIAL TOOLS Kit, Badge Removal (1453028-00-A) Fixture, Front Badge, Model 3 (1134702-00-A) Remove Prepare the badge removal tool with approximately 60 centimeters of monofilament line. With the hood closed, position the badge removal tool so that the monofilament line cuts under a corner

© 2019-2025 Copyright www.tmodel3.com