Tesla Model 3: Powertrain Coolant - Refill
Refill
- Remove the plugs from the hoses.
- Connect the powertrain supply hose to the male
fitting.
Caution:
Perform a push-pull test to verify that the hose
is fully seated.
- Connect the powertrain return hose to the female
fitting.
Caution:
Perform a push-pull test to verify that the hose
is fully seated.
- Install the lower clips (x3) that attach the lower
rear edge of the RH wheel arch liner to the body.
- Install the front HV battery skid plate. See Skid
Plate - HV Battery - Front (Remove and Replace).
- Remove the coolant drain from under the vehicle.
- Install the mid aero shield panel. See Panel - Aero
Shield - Mid (Remove and Replace).
- Connect 12V power. See 12V Power (Disconnect and
Connect).
- Perform a vacuum refill of the cooling system. See
Cooling System (Vacuum Refill).
READ NEXT:
Remove
Remove the rear subframe
assembly. See
Subframe Assembly - Rear (Remove
and Install).
SPECIAL TOOLS
Skt, Oil Filter, 63.5mm X 14
(1130484-00-A)
Kit, Drive Unit Oil Drain, Model
3 (1134264-00-A)
Procedure
SEE MORE:
Whenever Model 3 is moving and your foot is
off the accelerator, regenerative braking slows
down Model 3 and feeds any surplus energy
back to the Battery.
By anticipating your stops and reducing or
removing pressure from the accelerator pedal
to slow down, you can take advantage of
regenera
Install
If a new brake pedal assembly is to be installed,
install a new brake switch clip into the assembly.
Install the brake pedal assembly onto the studs (x4)
of the body.