Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Module - Steering Column Control - Remove

Tesla Model 3 2017-2025 Service Manual / Steering / Steering Rack and Lower Column / Module - Steering Column Control (Remove and Replace) / Module - Steering Column Control - Remove

 Module - Steering Column Control (Remove and Replace)

Remove

  1. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Disconnect 12V power. See 12V Power (Disconnect and Connect).
  4. Remove the driver airbag. See Airbag - Driver (Remove and Replace).
  5. Remove the steering wheel. See Steering Wheel (Remove and Install).

  Module - Steering Column Control - Remove

  1. Release the clips that attach the steering column upper shroud to the lower shroud, and then pull the upper shroud up.

  Module - Steering Column Control - Remove

  1. Remove the upper screws that attach the steering column lower shroud to the steering column.

  Module - Steering Column Control - Remove

  1. Remove the lower screw that attaches the steering column lower shroud to the steering column, and then remove the lower shroud from the vehicle.

  Module - Steering Column Control - Remove

  1. Remove and discard the retaining clip from the steering column control module electrical connector, and then disconnect the electrical connector from the steering column control module.
  2. Make sure that the loop in the clock spring is visible and the black square on the steering column control module indicates that the clock spring is in the center position.

  Module - Steering Column Control - Remove

  1. Remove the fastener that attaches the steering column control module to the steering column.
  2. Remove the steering column control module from the steering column.

    READ NEXT:

     Module - Steering Column Control - Install

    Install     

     Steering Rack (Dual Motor) (Remove and Replace)

       Caution: Vehicles built before March 25th, 2019 have 1st generation front subframes. Vehicles built on March 25th, 2019 and a

     Steering Rack (RWD) (Remove and Replace)

       Caution: Vehicles built before March 25th, 2019 have 1st generation front subframes. Vehicles built on March 25th, 2019 and after hav

    SEE MORE:

     Seat Back - 2nd Row - LH (Remove and Install)

    Remove Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace). Remove the LH 2nd row seat side bolster. See Bolster - Side - Seat - 2nd Row - LH (Remove and Replace). Release the clips that attach the bolster bracket, and remove the bracket fro

     Pipe - High Pressure - Compressor to Condenser - Install

    Install Install the compressor-to-condenser high pressure pipe into the vehicle. Connect the high pressure transducer electrical connector. Install a new O-ring to the compressor-to-condenser high pressure pipe. Position the compressor-to-condenser high pressure pipe into the A/C compre

    © 2019-2025 Copyright www.tmodel3.com