Tesla Model 3: Latch Actuator - Charge Port - Install
Install
- Install the new latch actuator to the vehicle.
- Install the screws that attach the latch actuator to the charge port. Torque 1.2 Nm
- Connect the latch actuator electrical harness connector.
- Install the release arm onto the latch actuator in the same position as when it was removed. Note: After installation, manually rotate the release arm and check that the latch actuator moves.
Caution: Ensure the latch actuator is oriented correctly, as shown below. Incorrect installation can result in inability to properly latch.
- Install the bolt that attaches the charge port
bracket to the body.
Torque 6 Nm
- Install the clips that attach the charge port electrical wiring harness to the body.
- Install the bolts that attach the charge port
assembly to the body.
Torque 6 Nm
- Install the bolt that attaches the charge port
electrical ground to the body.
Torque 6 Nm
- Install the charge port closeout panel to the vehicle. Secure the panel with clips (x7).
- Install the low voltage electrical wiring harness clip to the charge port closeout panel.
- Install the LH trunk side trim. See Trim - Side - Trunk - LH (Remove and Replace).
- Perform the penthouse air leak test. See Penthouse Air Leak Test.
- Reconnect 12V power. See 12V Power (Disconnect and Connect).
READ NEXT:
Harness - Charge Port to HV Battery (Single-Phase) (Remove and Replace)
DRAFT
Warning:
This procedure was derived from pre-production computer
models, and might not reflect the real-world situation. Warnin
SEE MORE:
Using Smart Summon
Open the Tesla mobile app, and press
SUMMON.
Press the Smart Summon icon located in
the center of the image of your Model 3. It
may take several seconds for Smart
Summon to start up.
Note: You can use Standby Mode to
eliminate the delay that occurs when
Smart Summon is starting up
HV Battery Air Leak Test
Pack Enclosure Leak Tester, HV Battery (1026636-00-A)
Pack Kit, Enclosure, Leak Test, HV Battery, Complete (1140501-00-A)
Kit, Encl Leak Test Adapters, HV Battery (1144879-00-A)
Procedure
Perform the vehicle electrical isolation procedure. See
Vehicle Electrical Isolation Procedure.
Remove the p
