Tesla Model 3: HV Battery Cooling System
Tesla Model 3 2017-2026 Service Manual / Battery System / HV Battery Cooling System
- Coolant - HV Battery (Drain and Refill)
- Penthouse Coolant (Drain and Refill)
- Penthouse Coolant Leak Test
- Platter Enclosure Coolant (Drain and Refill)
- Platter Enclosure Coolant Leak Test
- Tube - Input - Coolant - Power Conversion System (Remove and Replace)
- Tube - Output - Coolant - Power Conversion System (Remove and Replace)
READ NEXT:
Coolant - HV Battery (Drain and Refill)
SPECIAL TOOLS
Drive Unit Pressure Test Fixture (1053600-00-B)
Adapter, Coolant Reservoir Pressure Test (1130942-00-B)
Kit, Coolant Leak Test Adapters, Model 3 (1132185-00-B)
Kit, Coolant Drain &
Penthouse Coolant (Drain and Refill)
Penthouse Coolant- Drain
SPECIAL TOOLS
Drive Unit Pressure Test Fixture (1053600-00-C)
Kit, Coolant Leak Test Adapters, Model 3 (1132185-00-B)
Kit, Coolant Drain & Fill Adapters, M3 (1133843-00-A)
SEE MORE:
Duct - Air Wave - LH (Remove and Replace)
Remove
Remove the IP carrier. See
IP Carrier (Remove and Replace).
Remove the screws (x2) that attach the LH air wave duct to the cross bar
beam, and then remove the duct from the vehicle.
Install
Install the LH air wave duct to the cross car beam, and then install the
screws (x
Adjustable Top Loop (Remove and Replace)
Remove
Open both LH doors and lower both LH windows.
Move the LH front seat fully forward.
Release the clips that attach the LH upper B-pillar trim to the vehicle.
Tip: Release the clips at the bottom of the LH upper B-pillar trim first, and
then release the clips at the top of the trim.
© 2019-2026 Copyright www.tmodel3.com
