Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Harness - HV Battery to Rear Drive Unit - Install

Tesla Model 3 2017-2025 Service Manual / High Voltage System / HV Harnesses / Harness - HV Battery to Rear Drive Unit (Remove and Replace) / Harness - HV Battery to Rear Drive Unit - Install

Install

  1. Fully raise the handle on the rear drive unit HV electrical harness.

  Harness - HV Battery to Rear Drive Unit - Install

  1. Attach the HV connector lever lock onto the back of the HV electrical harness.
  2. Firmly connect the HV electrical harness to the inverter connector.

Caution: Make sure that the harness fits the connector squarely and tightly.

  1. While pressing the harness to the connector, remove the HV connector lever lock.

  Harness - HV Battery to Rear Drive Unit - Install

  1. While pressing the harness to the connector, fully lower the handle.

  Harness - HV Battery to Rear Drive Unit - Install

  1. Slide the release to lock the HV electrical harness.

  Harness - HV Battery to Rear Drive Unit - Install

  1. Install the bolt that attaches the HV harness bracket to the inverter. Torque 6 Nm

  Harness - HV Battery to Rear Drive Unit - Install

  1. Connect the rear drive unit inlet hose to the inverter coolant inlet, and then fasten the clip.

  Harness - HV Battery to Rear Drive Unit - Install

  1. Fasten the clip that attaches the rear drive unit inlet hose to the HV harness bracket.

  Harness - HV Battery to Rear Drive Unit - Install

  1. Connect the electrical harness to the inverter low voltage connector.

  Harness - HV Battery to Rear Drive Unit - Install

  1. Fasten the clip that attaches the low voltage electrical harness to the inverter.
  2. Install the rear subframe assembly. See Subframe Assembly - Rear (Remove and Install)

    READ NEXT:

     External Charging Connectors

    Mobile Connector Firmware Update - CHAdeMO Charging Adapter CAN Setup Connect the USB-CAN dongle to a laptop that is equipped with Toolbox Connect the CHAdeMO CAN programming connector to the USB-CAN

    SEE MORE:

     Hood (Remove and Replace)- Remove

    This procedure assumes the hood striker, hinges, bump stops, and plugs are undamaged. Inspect these components from the old hood and if necessary, replace with new parts. Remove RH shown, LH similar Release the clips that attach the LH and RH hood gas struts to the LH and RH hood strut b

     Actuator - Latch - Hood - Primary (Remove and Replace)

    Remove Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace). Remove the cabin intake duct. See Duct - Cabin Intake (Remove and Replace). Remove the hood latch cover. See Cover - Hood Latch (Remove and Replace). Remove the underhood storage unit. See Underhoo

    © 2019-2025 Copyright www.tmodel3.com