Tesla Model 3: Front Drive Unit
Tesla Model 3 2017-2025 Service Manual / Front Drive Unit
- Front Drive Unit Assembly
- Bushing - Front Drive Unit - RH (Remove and Replace)
- Drive Unit - Front (Remove and Install)
- Drive Unit - Front (Remove and Replace)
- Ground Strap - Front Drive Unit (Remove and Replace)
- Mount - Front Drive Unit - LH (Remove and Replace)
- Front Drive Inverter
- Hose - Inverter Inlet - Front Drive Unit (Remove and Replace)
- Hose - Inverter to Heat Exchanger - Front Drive Unit (Remove and Replace)
- Front Gearbox and Halfshafts
- Breather - Front Drive Unit (Remove and Replace)
- Bushing - Gearbox - Front Drive Unit (Remove and Replace)
- Gearbox Fluid - Front Drive Unit (Drain and Refill)
- Halfshaft - Front Drive Unit - LH (Remove and Replace)
- Heat Exchanger - Front Drive Unit (Remove and Replace)
- Hose - Heat Exchanger to Superbottle - Front Drive Unit (Remove and Replace)
- Oil Pump - Front Drive Unit (Remove and Replace)
- Oil Screen - Front Drive Unit (Remove and Replace)
- Seal - Oil - Differential to Halfshaft - Front Drive Unit - LH (Remove and Replace)
READ NEXT:
Bushing - Front Drive
Unit - RH (Remove and
Replace)
Remove
Remove the front subframe assembly from the vehicle.
See Subframe Assembly - Front (Dual Motor) (R
SEE MORE:
Receiver Dryer and Desiccant- Install
Install
Use 3/8 inch extensions to press the new desiccant filter into the
condenser. Lightly tap with a hammer to fully seat the filter.
Insert a new desiccant bag into the condenser.
Install the inner cap into the condenser, and press it in just below the
groove for the snap ring.
Remove
Locking Devices
General
Always replace locking devices with ones of the same design.
Caution: Do not use impact tools on fasteners that are threaded into
aluminum components.
Locking Tabs and Washers
Always inspect locking tabs and washers. Do not reuse, if damaged.
Pipe and Hose Unions
To prevent rotational damag
© 2019-2025 Copyright www.tmodel3.com
