Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Brake Pad Kit - Rear (Sport Brakes) - Remove

Tesla Model 3 2017-2025 Service Manual / Brakes / Brake Discs and Calipers / Brake Pad Kit - Rear (Sport Brakes) (Remove and Replace) / Brake Pad Kit - Rear (Sport Brakes) - Remove

Brake Pad Kit - Rear (Sport Brakes) (Remove and Replace)  

Remove

  1. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  2. Remove the LH and RH rear wheels. See Wheel (Remove and Install).
  3. Use Toolbox to place the vehicle into EPB Service Mode. See Release Parking Brake Using Toolbox.

  Brake Pad Kit - Rear (Sport Brakes) - Remove

  1. Using a flat head screwdriver, compress the brake piston by carefully pushing the caliper away from the brake rotor.

  Brake Pad Kit - Rear (Sport Brakes) - Remove

  1. Remove the rubber cap that covers the upper LH rear caliper to caliper bracket bolt.

  Brake Pad Kit - Rear (Sport Brakes) - Remove

  1. Remove the upper bolt that attaches the LH rear brake caliper to the LH rear caliper bracket.

  Brake Pad Kit - Rear (Sport Brakes) - Remove

  1. Remove the lower bolt that attaches the LH rear brake caliper to the LH rear caliper bracket.
  2. Use a brake caliper S-hook to hang the LH rear caliper on the body.

  Brake Pad Kit - Rear (Sport Brakes) - Remove

  1. Remove the brake pad from the LH rear brake caliper.

  Brake Pad Kit - Rear (Sport Brakes) - Remove

  1. Remove the brake pad from the LH rear brake caliper bracket.
  2. Brush the LH rear brake caliper and LH rear brake caliper bracket anti rattle springs with soapy water.

    READ NEXT:

     Brake Pad Kit - Rear (Sport Brakes) - Install

    Install   Install the brake pad on the LH rear brake caliper brac

     Brake Rotor - Front - LH (Remove and Replace)

    SPECIAL TOOLS Tool, Caliper Spreader, Model 3 (1134786-00-A) Remove Raise the vehicle and remove the front LH wheel. See Wheel (Remove and Install). Remove the bolt that attaches the LH fron

     Brake Rotor - Rear - LH (Remove and Replace)

    SPECIAL TOOLS Tool, Caliper Spreader, Model 3 (1134786-00-A) Remove Raise the vehicle and remove the LH rear wheel. See Wheel (Remove and Install). Use Toolbox to place the vehicle into EPB Serv

    SEE MORE:

     Trim - Side - Trunk - LH (Remove and Replace)- Install

    Install Connect the electrical connector to the puddle lamp. Install the push clips that attach the LH trunk side trim to the vehicle. Install the trunk garnish. See Garnish - Trunk (Remove and Replace) Install the trunk sill trim panel. See Trim - Sill - Trunk (Remove and Replace).

     Evaporator- Install

    Install Install the new evaporator into the HVAC assembly. Caution: Do not damage the temperature sensor when installing the new evaporator into the HVAC assembly. Note: Make sure that the evaporator slides into the HVAC assembly with the correct channels until the evaporator stops. The evap

    © 2019-2025 Copyright www.tmodel3.com