Tesla Model 3: ABS Modulator - Install

Install

1. Install the ABS modulator into the bracket.
2. Tighten the nuts (x2) that attach the ABS modulator to the bracket. Torque 8 Nm
3. Remove the tapes that cover the orifices of the new ABS modulator
4. Position the ABS modulator into the vehicle for installation. Align the bracket into the body, and then attach the tabs (x2).
5. Move the ABS modulator into position within the vehicle for installation.

 

6. Install the bolts that attach the ABS modulator to the LH frame rail. Torque 10 Nm

 

7. Fasten the clip that attaches the master cylinder brake lines to the bracket.

 

8. Install the master cylinder brake lines to the 4 tube bundle clip.

 

9. Install the master cylinder primary pipe nut to the ABS modulator. Torque 16 Nm

 

10. Install the master cylinder secondary pipe nut to the ABS modulator. Torque 16 Nm

 

10. Install the LH front brake pipe nut to the ABS modulator. Torque 16 Nm

 

12. Install the RH rear brake pipe nut to the ABS modulator. Torque 16 Nm

 

13. Install the LH rear brake pipe nut to the ABS modulator. Torque 16 Nm

 

14. Install the RH front brake pipe nut to the ABS modulator. Torque 16 Nm
15. Remove the oil pan from underneath the vehicle.

 

16. Install the clips that attach the main front harness to the LH frame rail area.

 

17. Connect the electrical connector to the ABS modulator.

   

18. Install the black and white clips (x2) that attach the main front harness to the body.

 

19. Install the bolts that attach G098 and G099 to the body. Torque 10 Nm
20. Install the 12 battery bracket. See Bracket - 12V Battery (RWD) (Remove and Replace).
21. Install the 12V auxiliary battery, but do not connect the negative battery terminal at this time. See Battery - 12V (Remove and Replace).
22. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
23. Install the hood latch cover. See Cover - Hood Latch (Remove and Replace).
24. Install the cabin intake duct. See Duct - Cabin Intake (Remove and Replace).
25. Reconnect 12V power. See 12V Power (Disconnect and Connect).
26. Install the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
27. Perform a bleed of the entire braking system. See Brake Fluid Bleed / Flush.
28. Install the front aero shield panel. See Panel - Aero Shield - Front (Remove and Replace).
29. Install all wheels. See Wheel (Remove and Install).
30. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
31. Remove the vehicle from the lift.
32. Perform a road test to make sure proper brake pedal feel and performance is present.

READ NEXT: