Tesla Model 3: Tires
- Tire - Front - LH (Dismount and Mount)
- Tire - Front - LH (Rebalance)
- Tire - Front - LH (Repair)
- Tire Rotation
READ NEXT:
Tire - Front - LH (Dismount and Mount)
Warning:
Always read and understand the tire equipment operator's
manual before operating the tire changer.
Note: These instructions are based on the Hunter T
Tire - Front - LH (Rebalance)
DRAFT
Warning:
This procedure was derived from pre-production computer
models, and might not reflect the real-world situation. Warnings
and cautions might be
Tire - Front - LH (Repair)
DRAFT
Warning:
This procedure was derived from pre-production computer
models, and might not reflect the real-world situation. Warnings
and caution
SEE MORE:
Motor - Recliner - Backrest - Driver Seat (Remove and Replace)
Remove
Remove the lumbar support assembly from the driver's seat back. See
Lumbar Support - Backrest - Driver Seat (Remove and Replace).
Remove and discard the clip that attaches the recliner tube to the
frame.
Use a rubber hammer to tap the recliner tube where the clip was located
Door - Rear - LH (Remove and Replace)
Door - Rear - LH (Remove )
Remove
Open the rear LH door, pass a shop towel halfway through the striker,
and then close the door so that it rests against the shop towel.
Remove the rear LH door glass.
Remove the LH rear door outer belt seal.
Remove the LH rear window regulator. See&nb
© 2019-2026 Copyright www.tmodel3.com
