Tesla Model 3: Spring and Damper Assembly - Front - LH - Install

Install

 

1. Install the nuts that attach the FUCA mount to the LH front spring and damper. Torque 23 Nm
2. Install the LH front spring and damper assembly into position in the vehicle.

 

3. Install the larger bolts that attach the spring and damper assembly to the shock tower. Torque 62 Nm

 

4. Install the smaller bolts that attach the spring and damper assembly to the shock tower. Torque 35 Nm

 

5. Install the clips that attach the LH shock tower cover to the body.

 

6. Hand-tighten the bolt and nut that attach the LH front spring and damper assembly to the lower control arm.

 

7. Install new nut that attaches the stabilizer bar link to the LH front spring and damper assembly. Torque 98 Nm

 

8. Install new nut that attaches the LH tie rod end to the knuckle. Torque 180 Nm

 

9. Install the bolt and new nut that attach the upper control arm to the knuckle. Torque 56 Nm

 

10. Dual Motor only: Install the nut that attaches the LH front jounce hose bracket to the vehicle. Torque 6 Nm

 

11. Connect the wheel speed sensor connector, and then connect the harness with the clips on the body and upper control arm.
12. Install the front LH wheel arch liner. See Wheel Arch Liner - Front - LH (Remove and Replace).
13. Install the LH front wheel. See Wheel (Remove and Install).
14. Install the cowl screen panel. See Panel - Cowl Screen (Remove and Replace).
15. Install the LH and RH wiper arms. See Wiper Arms (Remove and Replace).
16. Install the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
17. Install the hood latch cover. See Cover - Hood Latch (Remove and Replace).
18. Install the cabin intake duct. See Duct - Cabin Intake (Remove and Replace).
19. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
20. Perform a four wheel alignment. See Four Wheel Alignment (Check and Adjust).

READ NEXT: