Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Rear Drive Unit Assembly

READ NEXT:

 Bushing - Rear Drive Unit - Rear (Remove and Replace)

  DRAFT Warning: This procedure was derived from pre-production computer models, and might not reflect the real-world situation. Warnings and cautio

 Bushing - Rear Drive Unit - RH (Remove and Replace)

SPECIAL TOOLS Kit, Drive Unit Bushing R&R, Model 3 (1137785-00-A) Remove

 Fluid Coupling (55 Degrees) - Rear Drive Unit (Remove and Replace)

  SPECIAL TOOLS Kit, Svc Plug, Cooling Hose, Model 3 (1135762-00-A) Remove

SEE MORE:

 Sensor - Airbag - Front - Center (Remove and Replace)

Note: This procedure was formulated using a release candidate or production model. Follow safety requirements and use extreme caution when working on or near high-voltage systems and components. Remove Open all the doors. Lower all the windows. Remove the 2nd row lower seat cushion. See Sea

 Fascia - Rear (Remove and Install)

Remove Remove the 2nd row lower seat cushion Remove the trunk sill trim. Remove the LH and RH taillights. On each side of the vehicle, remove the bolt that attaches the corner of the rear fascia to the body. Torque 4 Nm Raise the vehicle partially. Release the clips and the push nut

© 2019-2026 Copyright www.tmodel3.com