Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Harness - 12V Battery Ground-Remove

Harness - 12V Battery Ground (Remove and Replace)

Remove

  1. Remove the cowl screen panel. See Panel - Cowl Screen (Remove and Replace).

Harness - 12V Battery Ground-Remove

  1. Remove and discard the nut that attaches the front harness ground wire to the 12V battery ground harness, and remove the wire from the harness.
  2. Remove the 12V auxiliary battery. See Battery - 12V (Remove and Replace).
  3. Remove the 12V battery bracket. See Bracket - 12V Battery (RWD) (Remove and Replace).

Harness - 12V Battery Ground-Remove

  1. Remove the bolt that attaches the thermal harness cover to the front body controller module, and then remove the cover from the module.

Harness - 12V Battery Ground-Remove

  1. Disconnect the thermal harness from the front body controller module connector.

Harness - 12V Battery Ground-Remove

  1. Release the clip that attaches the suction/liquid lines to the body near the TXV, and then move the electrical harness aside to gain access to the front body controller module.

Harness - 12V Battery Ground-Remove

  1. Remove the bolts (x9) that attach the front body controller module cover to the front body controller module, and then remove the cover.

Harness - 12V Battery Ground-Remove

  1. Remove and discard the bolt that attaches the battery ground cable to the front body controller module, and then remove the cable.

    READ NEXT:

     Harness - 12V Battery Ground-Install

    Install Install the battery ground cable to the front body controller module, and then install a new bolt to attach the cable to the module. Torque 8.5 Nm Visually inspect that the ground

     Harness - 12V Battery Positive (Remove and Replace)

     Harness - 12V Battery Positive- Remove

    Remove Remove the cowl screen panel. See Panel - Cowl Screen (Remove and Replace). Remove the 12V auxiliary battery. See Battery - 12V (Remove and Replace). Remove the 12V battery bracket. See

    SEE MORE:

     Cover - Airbag - Knee - Driver (Remove and Replace)

    Note: This procedure was formulated using a release candidate or production model. Follow safety requirements and use extreme caution when working on or near high-voltage systems and components. Remove Remove the driver knee airbag. Use a flat head screwdriver to apply pressure along t

     SIM Card - Car Computer (Remove and Replace)

    DRAFT Warning: This procedure was derived from pre-production computer models, and might not reflect the real-world situation. Warnings and cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Remove Remove

    © 2019-2025 Copyright www.tmodel3.com