Tesla Model 3: Front Seat Covers Pads and Trims
Tesla Model 3 2017-2025 Service Manual / Seats / Front Seat Covers Pads and Trims
- Cover - Outer Side - Driver Seat (Remove and Install)
- Foam - Backrest - Driver Seat (Remove and Replace)
- Foam - Cushion - Driver Seat (Remove and Replace)
READ NEXT:
Cover - Outer Side - Driver Seat (Remove and Install)
SPECIAL TOOLS
Key, Seat Belt Release, Model 3 (1133787-00-A)
Remove
Open the LH front door.
Move the driver's seat fully forward, and adjust the seat cushion height
to maximum.
Caution:
Do n
Foam - Backrest - Driver Seat (Remove and Replace) - Remove
Remove
Remove the driver seat. See
Seat - Driver (Remove and Replace).
Remove the driver headrest trim. See
Trim - Headrest - Driver (Remove and Replace).
Remove the side outer cover from the
SEE MORE:
Hose - Heat Exchanger to Superbottle - Front Drive Unit (Remove and Replace)
Remove
Remove the superbottle. See
Superbottle (Dual Motor) (Remove and Replace).
Install
Installation procedure is the reverse of removal.
Caution:
Perform a push-pull test to verify that the hose is fully seated
Bumper - Rear (Remove and Replace)
Remove
Remove the rear fascia.
Release the clips that attach the rear Bluetooth passive entry antenna
electrical harness to the rear center bracket assembly.
Remove rear Bluetooth passive entry antenna.
Remove the center rear bracket.
Remove the nuts that attach the rear bumper to
© 2019-2025 Copyright www.tmodel3.com
