Tesla Model 3: Front Seat Assemblies and Hardware
Tesla Model 3 2017-2025 Service Manual / Seats / Front Seat Assemblies and Hardware
- Lumbar Support - Backrest - Driver Seat (Remove and Replace)
- Shell - Seat Back - Driver (Remove and Replace)
- Seat - Driver (Remove and Replace)
- Trim - Headrest - Driver (Remove and Replace)
READ NEXT:
Lumbar Support - Backrest - Driver Seat (Remove and Replace)
Remove
Remove the driver seat back shell. See
Shell - Seat Back - Driver (Remove and Replace).
Release the clips that attach the outboard side of the seat back
cover to the seat ba
Shell - Seat Back - Driver (Remove and Replace)
Remove
Remove the driver headrest trim from the seat. See
Trim - Headrest - Driver (Remove and Replace).
Release the clips that attach the seat back shell to the driver seat,
lift
Seat - Driver (Remove and Replace)
Seat - Driver (Remove and Replace)- Remove
SPECIAL TOOLS
Key, Seat Belt Release, Model 3 (1133787-00-A)
Torx Plus T45 (1082447-07-A)
Remove
Note: Though the driver seat is described, the procedure
SEE MORE:
Spoiler - Rear (Retrofit using Tape)
Procedure
Clean the installation surface of the spoiler with isopropyl alcohol
(IPA) wipes, and allow it to dry before continuing.
Note: Clean any moisture or contaminates that might be
present from rain or vehicle washing, otherwise this might result in poor
adhesion of the rear spoiler.
Windshield (Remove and Replace)
Windshield (Remove and Replace) - Remove
Remove
Remove the cowl screen panel. See Panel - Cowl Screen (Remove and
Replace).
Disconnect the electrical harness from the windshield heater connector.
Partially close the hood.
Caution:
Use care not to damage the dashboard.
Place a fende
© 2019-2025 Copyright www.tmodel3.com
