Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Cover - Airbag - Knee - Front Passenger (Remove and Replace)

Tesla Model 3 2017-2026 Service Manual / Instrument Panel / Cover - Airbag - Knee - Front Passenger (Remove and Replace)

READ NEXT:

 Cover - Airbag - Knee - Front Passenger (Remove and Replace) - Remove

Remove Disconnect 12V power. See 12V Power (Disconnect and Connect). Remove the passenger footwell cover. See Cover - Footwell - Passenger (LHD) (Remove and Replace). Remove the T20 bolt

 Cover - Airbag - Knee - Front Passenger (Remove and Replace) - Install

Install Install the passenger knee airbag into the airbag cover by installing the rear tabs first, and then press down against the airbag while pushing upwards on the edge of the cover.

 Cover - Footwell - Driver (Remove and Replace)

Remove Release the clips and remove the screw that attach the driver footwell cover to the vehicle. Torque 2.5 Nm Disconnect the electrical connector from the puddle light, and then

SEE MORE:

 Seal - Hood (Remove and Replace)

Remove Open the hood. Release the seal from the underhood storage unit, and then remove the seal from the underhood storage unit. Install Installation procedure is the reverse of removal, except for the following: During installation, align the line from the seal to the line from the

 Seal - Oil - Differential to Halfshaft - Rear Drive Unit - LH (Remove and Replace)

SPECIAL TOOLS Adapter, Coolant Reservoir Pressure Test (1130942-00-B) Install Tool, Output Seal, Model 3 (1131206-00-A) Remove Remove the LH rear drive unit halfshaft. See Halfshaft - Rear Drive Unit - LH (Remove and Replace). Use the special tool to remove the LH output seal from the re

© 2019-2026 Copyright www.tmodel3.com