Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Brake Pedal - Remove

Tesla Model 3 2017-2025 Service Manual / Brakes / Brake Pedal / Brake Pedal (Remove and Replace) / Brake Pedal - Remove

 Brake Pedal (Remove and Replace)

Remove

  1. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Disconnect 12V power. See 12V Power (Disconnect and Connect).
  4. Remove the driver footwell cover. See Cover - Footwell - Driver (Remove and Replace).
  5. Remove the driver knee airbag. See Airbag - Knee - Driver (Remove and Install).
  6. Remove the LH footwell duct. See Duct - Footwell - LH (Remove and Replace)

  Brake Pedal - Remove

  1. Disconnect the brake pedal and the accelerator pedal electrical connectors.
  2. Remove the brake light switch. See Switch - Brake Light (Remove and Replace).

  Brake Pedal - Remove

  1. Remove the brake clevis pin cotter pin.

  Brake Pedal - Remove

  1. Remove the brake clevis pin that attaches the brake pedal to the electromechanical brake booster.

  Brake Pedal - Remove

  1. Release the clips that attach the electrical harness to the brake pedal assembly.

  Brake Pedal - Remove

  1. Remove and discard the nuts (x4) that attach the brake pedal assembly to the vehicle.
  2. Remove the brake pedal and the accelerator pedal as an assembly from the vehicle.

    READ NEXT:

     Brake Pedal - Install

    Install If a new brake pedal assembly is to be installed, install a new brake switch clip into the assembly. Install the brake pedal assembly onto the st

     Switch - Brake Light (Remove and Replace)

        Remove Remove the LH center console side panel carpet. See Carpet - Side Panel - Center C

     Wheel and Tires

    SEE MORE:

     Overview

    The touchscreen displays the status of Model 3 at all times. What you see depends on whether the vehicle is: Parked (shown below). Driving Charging When Model 3 is parked, the status area shows the gear, estimated range, and an overhead view of the car with buttons you can touch to o

     Cooling System (Vacuum Refill)

    SPECIAL TOOLS Refiller, Cooling System (1050448-00-A) Procedure Note: It is important that the drive rails remain off throughout this procedure. If the drive rails become active, such as from touching the brake pedal, an error is displayed in Toolbox. If this happens, you must disable the drive r

    © 2019-2025 Copyright www.tmodel3.com