Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Brake Caliper - Rear - LH - Install

Tesla Model 3 2017-2024 Service Manual / Brakes / Brake Discs and Calipers / Brake Caliper - Rear - LH (Remove and Replace) / Brake Caliper - Rear - LH - Install

Install

  Brake Caliper - Rear - LH - Install

  1. Install new bolts that attach the LH rear brake caliper bracket to the knuckle. Torque 83 Nm

  Brake Caliper - Rear - LH - Install

  Brake Caliper - Rear - LH - Install

  1. Install a new bolt and 2 new washers that attach the brake hose to the LH rear brake caliper. Torque 42 Nm
  2. Remove the oil drain from underneath the vehicle.
  3. Connect the electrical connector to the LH rear brake caliper.

  Brake Caliper - Rear - LH - Install

  1. Install the LH rear brake caliper electrical harness clips. Torque 5 Nm
  2. Lower the vehicle.
  3. Remove any wheel chocks, and then shift the vehicle into Park.
  4. Perform the bleed procedure for the LH rear brake caliper. See Brake Fluid Bleed - One Caliper.
  5. Install the LH rear wheel. See Wheel (Remove and Install).
  6. Install the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  7. Test drive the vehicle to confirm that the brake pedal feel is normal.

    READ NEXT:

     Brake Pads - Burnishing

    Warning: Be sure to comply with all local traffic safety laws and only perform maneuvers in a suitable location where such activity is legal, with little to no traffic Procedure On the touchscre

     Brake Pad Kit - Front (Base Brakes) (Remove and Replace)

    Remove Remove the LH front wheel. See Wheel (Remove and Install). Remove the brake pad retaining pins that attach the anti-rattle spring from the LH front brake caliper. Remove the front

     Brake Pad Kit - Front (Sport Brakes) (Remove and Replace)

    SEE MORE:

     Carpet - Rear Trunk (Remove and Replace)

    DRAFT Warning: This procedure was derived from pre-production computer models, and might not reflect the real-world situation. Warnings and cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Do not redistr

     Evaporator- Remove

    Remove Remove the HVAC assembly. See HVAC Assembly (Remove and Replace). Put the HVAC assembly on a working surface. Make sure that the HVAC assembly is on its side with the HVAC inlet facing up. Remove the TXV O-ring seals (x2) from the HVAC assembly. Release the clips that attach the

    © 2019-2024 Copyright www.tmodel3.com