Tesla Model 3 Owners & Service Manuals

Tesla Model 3: Applique - B-Pillar - LH (Remove and Replace) - Remove

Tesla Model 3 2017-2025 Service Manual / Exterior Fittings / Exterior Trim / Applique - B-Pillar - LH (Remove and Replace) / Applique - B-Pillar - LH (Remove and Replace) - Remove

Applique - B-Pillar - LH (Remove and Replace)- Remove

Remove

  1. Open the LH front and rear doors.

Applique - B-Pillar - LH (Remove and Replace)- Remove

  1. Release the clips that attach the B-pillar applique fastener cover to the vehicle, and then remove the cover.

Applique - B-Pillar - LH (Remove and Replace)- Remove

Applique - B-Pillar - LH (Remove and Replace)- Remove

  1. Remove the bolts that attach the B-pillar applique to the body, but do not remove the applique from the vehicle at this time.

Applique - B-Pillar - LH (Remove and Replace)- Remove

  1. Release the B-pillar applique from the body, and then disconnect the camera connectors from the B-pillar applique.

Caution:

Use caution not to damage the camera connector.

  1. Remove the B-pillar applique from the vehicle.

    READ NEXT:

     Applique - B-Pillar - LH (Remove and Replace) - Install

    Install Connect the camera connectors to the B-pillar applique, and then position the applique onto the vehicle. Install the bolts that attach the B-pillar applique to the body.  To

     Brightwork - Upper - LH (Remove and Replace)

    Remove Open the LH doors. Pull down to release the front and rear primary body seals from the LH upper brightwork. Note: It is not necessary to release the seals from the top of the B-p

     Cover - Rocker Panel - Lower - LH (Remove and Replace)

    Remove Release the LH lower rocker panel bolt covers. Remove the bolts that attach the LH lower rocker panel cover to the body.  Torque 5 Nm Front Rear Release the cli

    SEE MORE:

     Duct - Footwell - RH (Remove and Replace)

    DRAFT Warning: This procedure was derived from pre-production computer models, and might not reflect the real-world situation. Warnings and cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Remove Remove

     Closeout - Armrest - 2nd Row (Remove and Replace)

    Remove Remove the 2nd row armrest. See Armrest - 2nd Row (Remove and Replace). Release the clips and tabs that attach the 2nd row armrest closeout to the 2nd row seat, and then remove the armrest closeout. Install Installation procedure is the reverse of removal.

    © 2019-2025 Copyright www.tmodel3.com